- Unpack the Receipt bac and the Perforation cutter from the carton box.
- Take out the protective material from the perforation cutter.
- Turn the cover forwards 1. Unscrews the two screws on the left side 2 and right side 3, which maintains the paper guide
1 2 3 - Open the Rear Unit and remove the Paper Guide.
Caution: The perforation cutter is heavy; handle with care and use the handle
- Install the Perforation Cutter in the specific emplacements in each side 4 & 5.
4 5
Ensure each shaft of each side is correctly inserted in the housings
- Connect the I/F cable in the connector in the left side (from back side).
- Close the Cover Rear
- Insert the Supports for the receipt bac into the holes of the perforation cutter on each side.
- Hang the receipt bac on the support
- Final configuration
MAJ11/06/17 Error B200 means the printhead voltage or temperature is not normal. The Printhead could be defective.... but first, try these solutions below: Solution 1 : Disconnect the power cable from the printer. Wait 1 hour. Connect the power cable Solution 2 : Check and Clean Head contact pin condition of the carriage unit Check Cable connection especially the carriage FFC Solution 3 : Turn off the power Open the panel Turn on the power Wait for print carriage to start moving to the left. Let it go past half way Before print carriage reaches left hand side shut the cover. Leave the Printer turned on Solution 4 : Unplug the power cable. Open the printer Push the whole print head mechanic to the center While the printer still open, plug the power and turn it ON. When the printhead still moving and is going to the very LEFT, close the cover. Wait until its boot up. Solution 4a: Take out all of the ink cartridges Lift up the gr
Comments